Test Printer Argox X-10000Vl Manual Describing The
Test Printer Argox X-10000Vl Series Printers Use

DIP switch 1. Turn off the printer. Switch 2. Press and hold the CANCEL button and turn on the Direct printer.

Limitation of liability SATO Corporation andor its subsidiaries in Japan, the United States, and other countries make no representations or warranties of any kind regarding this material, including, but not limited to, implied warranties of merchantability and fitness for a particular purpose.

Getting Started 4.

Troubleshooting Unpacking Connecting the Power Cord LED and LCD Diagnosis Internal Parts and Features Media Problems Loading Ribbon Ribbon Problems.

Test Printer Argox X-10000Vl Manual Describing The

This users manual describing the General Specifications Xellent Series printer models, will help you get to know your new Printer Programming Language A, PPLA printer.

Note: If damage has occurred, contact your shipping company Quick immediately to file a claim.

Guide 3. Check whether you have received the following accessories together with the printer.

Connecting the Power Cord Before setting up and connecting the printer you should consider the following.

WARNING Do not operate the printer in an area where it might get wet.

Find a solid flat surface with adequate room for the printer and enough space above for media and ribbon access.

This section can be referred to, for X-Series to use transfer thermal printing.

Test Printer Argox X-10000Vl Series Printers Use

The sample steps below are based on ribbon wound ink-side in as an example.(X series printers use ribbon wound ink-side in as default.

The steps to switch for ribbon wound ink-side out are listed as follows: Pull and move the SHAFT RIBBON ADJ to Outside: Ribbon.

Then install the ribbon: The X-Series printers offer three different loading modes: standard, peel-off, or with a cutter.

Remove the outside media guide.

Figure 2) 1. Insert the media roll into the media supply spindle and move the media guide to the inside.

Figure 1) Media Guide Head.

Return the outside media guide, close the bracket, and hook the head latch.

To enable Peeling function, set by the LCD panel.

Make sure the peeler sensor is out of the ribbon path when installed.

The printer will Function of the label sensor is to detect the gap, notch, or holes of then feed the labels through the cutter automatically.

X-3200Z X-3200E X-3200ZE models have a LCD that shows: Buttons.

PRINT -8 15 mm 0 mm Controls vertical print THERMAL TRANSFER OFFSET positions.

BACK BACK 1040 mm 21 mm Available only when DISTANCE BACK FEED is PEELER enabled.

INSTALLED BASE 099 (PPLA) Available only in READER Available only in DARKNESS PPLA and PPLB INSTALLED -2828 (PPLB) PPLB printer.

X-2300ZE. X-3200E.

X-3200ZE): shift sign position.

Item Range Factory Remarks (ex.

Default CANCELRESET.: DHCP.

Steps as below: After the media is loaded, please perform media calibration to 1.

Font Symbol Set 7.

Print Mode (Thermal Transfer or Direct Thermal) 8.

DIP switch 1. Turn off the printer.

Switch 2. Press and hold the CANCEL button and turn on the Direct printer.